Meridian America Link/Customer Controlled Routing Procedure 13 Changing AML link 0 parameters

484Chapter 15: Link configuration

Procedure 13: Changing AML (link 0) parameters

Meridian Link and CCR are shipped with a default configuration for the AML. If the default configuration is not appropriate for your system, you can use this procedure to change it. Note that you cannot change the values for the protocol, link type, and port type parameters. For more information about AML parameters, refer to Table 141 at the end of this procedure.

!

CAUTION

Risk of potential data loss

Do not use the change link command without the direction of Nortel support personnel or host computer support personnel.

1Log in as mlusr (if you are not already logged in). The default password is mlusr.

2At the Òmlusr>Ó prompt, type display link 0 and press [Return] to see the current configuration for the link to the Meridian 1 system.

The default link configuration appears, as shown below.

Figure 259

Link 0 parameters

Protocol:	HDLC	Link type: 1
Machine ID: SL16
Delay: 0
Port type:	H	Physical DTE(0)/DCE(1):	0
PDN type:	0	Maximum Frame length:	135
Baud rate:	19200	Fail timer: 50
RFS timer:	150	Internal address: 1
Remote address: 3		T1: 20
Maximum out frames (K): 7		Maximum trans attempts: (N2): 8

mlusr>

553-3202-210 Standard October 1998