(See your hard drive’s documentation for the location of the con- nector.)
If desired, connect a second drive as described above.
Unlike floppy drives, IDE hard drives can connect to either end of the cable. If you install two drives, you will need to set one as the master and one as the slave by using jumpers on the drives. If you install only one drive, set it as the master.
2.9 Solid State Disk
The
2.9.1 CompactFlash (CN26)
The CompactFlash card shares a secondary IDE channel which can be enabled/disabled via the BIOS settings.
2.10 Floppy drive connector (CN18)
You can attach up to two floppy drives to the
A
2.10.1 Connecting the floppy drive
1.Plug the
2.Attach the appropriate connector on the other end of the cable to the floppy drive(s). You can use only one connector in the set. The set on the end (after the twist in the cable) connects to the A: drive. The set in the middle connects to the B: drive.
3.If you are connecting a 5.25” floppy drive, line up the slot in the printed circuit board with the
15 | Chapter 2 Installation |