Onkyo TX-SR605, TX-SA8560, TX-SA605 operating instructions AV Component Hookup

AV Component Hookup

See the other side of this sheet for the Speaker hookup.

With an HDMI cable you can send both audio and video with a single cable, making connecting simple and keeping wires neat.

If you have an HDMI-compatible TV and players, you can connect them to the AV receiver with HDMI cables. Digital audio signals received

at HDMI IN 1 or 2 are output by the speakers and headphones connected to the AV receiver.

TV

HDMI

IN

IF NO HDMI

DIGITAL AUDIO VIDEO

OUT OUT OUT

COAXIAL L

R

If your TV or player doesn’t support HDMI, use the analog or digital connections shown below.

DVD player

TV

VIDEO 1

IN

HDMI

OUT DVD player

				Coaxial feed from
	Cable/			TV antenna
HDMI				If you are not using
OUT	satellite	(e.g., RF IN)		Cable/satellite box,
		Antenna input		please refer to the
				instruction manual.
Setting the Monitor Out	On the front panel		Menu
	TUNING	PRESET	1.	Input/Output Assign
			2.	Speaker Setup
When the TV is connected to an HDMI			3.	Audio Adjust
			4.	Source Setup
input, the HDMI Monitor setting on the AV			5.	Listening Mode Preset
			6.	Miscellaneous
receiver/AV amplifier must be set to “Yes.”			7.	Hardware Setup
			8.	Lock Setup

Please ensure the monitor input (VIDEO 1, VIDEO 2, VIDEO 3, etc.) selected corresponds to actual connection used.

					Coaxial feed from
		L			TV antenna
COAXIAL		R	Cable/		If you are not using
					Cable/satellite box,
OUT	OUT	OUT	satellite	(e.g..RF IN)
					please refer to the
DIGITAL	VIDEO	AUDIO		Antenna input

instruction manual.

SETUP ENTER

Assigning the Digital Input

On the front panel

Assigning the HDMI Input

If you connect a video component to an HDMI input, you must assign that HDMI Input to an input selector in Setup.

If you make the same connections as shown here, you must assign the “DVD” setting to “IN1,” and assign the “CBL/SAT” setting to “IN2.”

1.Input/Output Assign

1.Monitor Out

2.HDMI Input

3.Component Video Input

4.Digital Input

1–1. Monitor Out

HDMI Monitor Yes

1.Input/Output Assign

1.Monitor Out

2.HDMI Input

3.Component Video Input

4.Digital Input

1–2. HDMI Input

DVD		IN 1
VCR/DVR	- - -
CBL/SAT		IN 2
GAME/TV	- - -
AUX	- - -

If there's no sound, press the [DIGITAL INPUT]

button repeatedly until sound is heard. The digital input is now properly assigned.

If you connect your DVD player to the AV receiver’s COAXIAL 1 DIGITAL IN, and your cable/satellite receiver to the COAXIAL 2 DIGITAL IN, as shown, it’s not necessary to assign the digital input.

DIGITAL INPUT