System Setup
1.6 LAST MEMORY
ON: During a playback or in the paused/stopped status each time you open the disc tray or turn off the player, the unit will memorize the last playback time. Next time when you insert the same disc and close the disc tray to load the disc, the unit will play from the memorized point.
OFF: Disable the last memory function.
2 AUDIO SETUP PAGE
2.1ANALOG AUDIO SETUP 2.1.1 DOWNMIX
LT/RT: The
STEREO: The
3D SURROUND: This mode creates a virtual surround effect from stereo or
5.1CH: Turn off the DOWNMIX mode. If the unit is connected to
NOTE: This function only applies to the Dolby AC
2.1.2 FRONT, CENTER, REAR SPEAKER and SUBWOOFER
Only when the DOWNMIX mode is turned off (DOWNMIX is set to 5.1CH) are the CENTER SPEAKER and REAR SPEAKER activated. The FRONT SPEAKER can be set to LARGE or SMALL. The CENTER SPEAKER, REAR SPEAKER can be set to LARGE, SMALL or OFF and the SUBWOOFER can be set to ON or OFF.
NOTE:
If the speaker is set to LARGE, the output level will be higher than that of SMALL. If the speaker is set to SMALL, the output level will be lower than that of LARGE. If a speaker is set to OFF, no audio is outputted from it.
2.1.3 DIALOG
When DOWNMIX is set to LT/RT or STEREO, this item is available. Adjust the value of this item to control the dialog volume.
NOTE: When playing 5.1CH disc, this item can be used to adjust the volume of the speakers.
2.1.4 D.R.C. (Dynamic Range Control)
You can set this item to AUTO, ON or OFF.
2.2.DIGITAL AUDIO SETUP 2.2.1 DIGITAL OUTPUT
SPDIF OFF: There will be no digital audio signal output. (Coaxial off)
SPDIF RAW: The digital audio signal output will be in its raw format.
SPDIF PCM: The digital audio signal output will be in PCM format.
2.2.2 LPCM OUTPUT
When DIGITAL OUTPUT is set to SPDIF PCM, this item is available.
Select a sample rating for the digital audio output. There are two options, 48KHz and 96KHz. NOTE: Some amplifiers don't support 96KHz sampling which will affect the coaxial output.