Tecra 780CDM / 780DVD Disassembly Overview, (cont.)
To assemble the FDD, follow the steps below. 1. Seat the FDD in the bracket and
secure the bracket with four M2x3 silver screws. Tighten screws to a torque of less than 2.2 kgfcm.
2. Insert the flexible cable into the connector. Press gently to assure a firm connection.
3. Seat the FDD in the lower plastic frame and set the upper shield cover in place.
4. Seat the flexible cable connector into the lower plastic frame.
5. Set the upper plastic frame in place, snap the two latches closed and secure six M2x6 silver screws.
CAUTION: Be very careful not to press on the top or bottom of the HDD. Pressure can destroy data or damage the drive.
To remove the HDD pack, follow the steps below. 1. Turn off the power to the computer.
Disconnect the AC adapter and all external cables connected to the computer.
2. Remove the battery pack.
3. Turn the computer upside down.
4. Slide the HDD cover to the right and push the HDD pack forward until the back edge is aligned with a marker next to the HDD slot.
5. Lift up on the cover to remove the HDD pack.
To disassemble the HDD Pack, follow the steps below.
1.
2.
í
î
Images / text continued on the next page
Toshiba TRR | Page 10 | 4/00, Tecra |