Before playing Your DVD Disc

	Before playing Your DVD Disc
Connecting to a Dolby Digital Amp	When connecting to output componets, refer to "Connection" Chapter and output components’ manual,.
Connecting to a Dolby Digital Amp	Turn on the power of the Amplifier, if it is connected.

Rear Panel

First, turn on the power of TV, and press TV/Video button.

75 ohm Coaxial Cable

Cable

To digital audio output

Receiver equipped with a

Dolby digital decoder

Front

SpeakerCenter Speaker

(left)

Sub

Speaker

Rear Speaker (left surround)

Front Speaker (right)

Rear Speaker (right surround)

●"No disc" is displayed on the screen, following "Loading..."

Reference ● The player is automatically turned off, if "No disc" is on the screen for 8 minutes.

●If is on the screen when you pressed certain button, it means that this button is not used in this disc which is being played.

●DVD disc must be recorded in Dolby Digtal.

●You must have Dolby Digital decoder and 6 channel Amp, 5 speakers and 1 bass woofer.

●You must set Digital Out of AC3 at "Raw" in Audio Setting

●This product is manufactured by technical co-operation with Dolby Laboratories

this symbol and trademark are reserved for Dolby Laboratories.

Caution �When connecting an amplifier equipped with Dolby Digital, connect it in the same way as shown above

�When connecting it, refer to the Audio system's manual.

�Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the speakers may be damaged by high volume levels.

�Turn off the receiver before you connect or disconnect the DVD player's power cord. If you leave the receiver power on, the speakers may be damaged.

Caution �Do not move DVD player when it is playing. This may cause damages to the disc.

�Be sure to press	button to eject disc.
If you eject disc by force, disc may be damaged.

�Certain function may not operate or operate differently depending on the disc. In this situation, refer to the contents of the disc case.

Connecting to a Dolby Digital Amp