Philips 9000HR manual How To... Replace the DC Controller Assembly, Main Cable, Mounting Screws4

Life Fitness Models 9000HR, 8500, and T9i Treadmills

How To... Replace the DC Controller Assembly

Tools Required: Phillips screwdriver, wire cutters

1.	Turn the unit power OFF at the ON/OFF switch, and then				Main Cable
	unplug the line cord at the wall outlet.
2.	Remove the four Phillips SCREWS securing the MOTOR
	COVER to the FRAME. Lift off the motor cover and set it
	aside.
3.	Remove CABLE TIES along the CROSS FRAME.
4.	Remove the four SCREWS from the front of the unit and
	lift out the DC CONTROLLER to access the wiring.		DC Controller
5.	To ensure correct wiring locations, mark all wiring		Mounting Screws(4)
	connectors on the DC CONTROLLER before removal.			DC Controller
	Once all wires are tagged and identified, disconnect
	connectors at the back of the DC CONTROLLER.
6.	Install the provided 120V or 230V POWER / LINE FILTER		White
	CABLE as shown in FIGURES A and B.	Black
7.	Install the provided VOLTAGE JUMPER as shown in
	FIGURE C.
	Note: The New DC Controller will be equipped with a
	Cable / Connector instead of a surface mount connector
	(P1) found on the previous version. This connector					Green
	attaches to the 3-pin connector coming from the treadmills

line filter.

8.Install the DC Controller Board in reverse order of removal.

FIGURE A - 100+ Volt Configuration

White

BlackGreen

FIGURE C - Voltage Jumper FIGURE B - 220+ Volt Configuration

M051-00K60-A017