Coleman 9277-139 owner manual Using Frame Clips, Attach Rainfly, Attach Tent to Frame

Page 2

Attach Tent to Frame

Grommets for rainfly pole

3 Using Frame Clips

 

–Attach frame clips along

the edges of tent to frame poles. (illus. 5), (illus. 6)

–Make any adjustments to the tent corner stakes that are needed.

illus. 6 Assembled tent without rainfly.

illus. 5

Frame clips

4 Attach Rainfly

–Assemble rainfly poles by interlocking shock-corded pole.

–Insert rainfly poles through pole sleeves located at the center edges of the underside of rainfly.

(illus. 7), (illus. 8)

–Drape rainfly over tent frame, pole side down. Rainfly poles should be over doors.

–Connect the six elastic loops with “S” hooks, (found at the rainfly corners) to the six rings located at the end of the stake loops at the corners of the tent.

–Insert the tips of the rainfly poles into the grommets on the front and rear of tent. (See above illus. 6)

–Secure rainfly with attachments located on underside of fly. (illus. 8)

–Stake out the tent with (2) side guylines and (4) corner guylines.

Clear window

illus. 7 Insert rainfly pole piece into pocket on underside of rainfly

Rainfly pole through pole sleeves

Rainfly pole in

 

grommet

Corner

Corner

guyline

 

guyline

Side

 

guyline

“S” hooks attach to

Underside of

rings at the corners

rainfly attaches

illus. 8 Completed tent with rainfly.

to frame poles

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be mini- mized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

Never store tent, even for a short period of time, without drying it thorough- ly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. We recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN CHINA Rev. 7/03

Do not leave your tent set-up for weeks at a time, be aware that expo- sure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

See owners manual for more tips.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA

Image 2
Contents Tacoma 13’x9’ Layout & Positioning of Tent, Pole AssemblyWhen You Are Ready To Set Up Your Tent Connect Frame to TentAttach Tent to Frame Using Frame ClipsAttach Rainfly