Understanding the control panel
Here I’m in command
Making the right choice is important. And it’s easy. | E | |
| D | G |
|
|
|
CFB A
Programme selector knob Use this knob to select the wash programme.
Turn this knob clockwise only. To select a programme, you should turn the knob so that the symbol/number of the desired programme is in line with the pointer on the knob.
Now press on/off button F (position I), pilot lamp G will start flashing.
After 5", the setting will be accepted, pilot lamp G will stop flashing (staying lit) and the wash cycle will begin.
Should you wish to interrupt the programme in progress or set a new one, select one of the symbols 
(Stop/Reset) and wait 5" : when the cancellation has been accepted, pilot lamp G flashes, and you can then turn the appliance off.
After the wash cycle has been set and accepted by the washing machine, turning the knob will have no effect (except for when it is on position 
Stop/ Reset).
Temperature control knob
It is used to set the wash tempe- rature in the recommended programme table on pag. 4. It also allows you to reduce the tempe- rature recommended for the selected programme, and even to set a cold wash cycle (
).
Detergent dispenser
It is divided into three compartments:
1.Detergent for
2.Detergent for the main cycle wash;
3.Fabric conditioner.
Anti-crease
This button allows you to interrupt a programme (on symbol 
) keeping the washing soaking in water before the spin cycle. It is a very useful button in particular because it can be used for delicates and synthetics. It is only to be used with wash programmes for synthetic fabrics, silk and curtains when it is impossible for you to take the washing out immediately. Before opening the washing machine door, finish the wash cycle as follows:
Silk and curtains: press button D and the machine will drain the
water.
Synthetic fabrics: press button D if you want a spin cycle, or turn knob A to symbol 
if you want the water to be drained.
With “Daily wash”, this function is not enabled.
Extra Economy
Reduces water consumption during the rinse cycles. We recommend that you use this function only with small laundry loads, dosing the detergent proportionally.
On-off
When button F is pressed, the washing machine is switched on, when it is not the machine is switched off.
Turning the appliance off does not cancel the selected programme.
The
Lamp G flashes when the appliance is switched on and awaiting a programme to be set. A steady light means the appliance has accepted the selected programme.
3
2
1
The detergent dispenser is here. 
3Instructions for installation and use