Owner's Manual | Model No. 875.199810 |
Owner's | Manual | Model No. 875.199810 |
,=, ..m | , | , |
Toolruns !. Grit or gum in tool slowor v_ll
notoperate.
2. No oil in tool
3, Low air pressure
4.Air hose leaks
5.Pressure drops
Mois_re | 1. V_ter in tank |
browing out
of toot
2.Water in the air lines/ hoses
1.Flush the tool with air tool oil, gum solvent, or an equal mixture of SAE 10 motor oil and kerosene. Lubricate the tool after cleaning.
2, Lubricate the tool according tO the lubrication inslruclions in this manual.
3a. Adjust the regulator on the lool to the
maximum setting (If applicable).
3b. Adjust the compressor regulator to tool maximum while the tool is running free
4.Tighten and seal hose fittings if leaks m'e found.
5a. Be sure the hose is the proper size.
Long hoses or tools using
large volumes of air may require a hose with an I.D. of 1/2" or larger depending on the total lenglh of the hose.
5b. Do not use multiple number of hoses connected together with quick connect fittings. This causes additional pressure drops and reduces the tool power. Directly connect the hoses together.
1.Drain tank. (See air compressor manual). Oil tool and run until no water Is evident. Oil
too} again and run
2a. Install a water separator/fitter.
NOTE: Separators only work properly when the air passing through the separator is cool. Locate the separator/filter as far as possible from the compressor.
2b. Install an air dryer,
2c, Anytime water enters the tool, the tool
should be oiled immediately.
Impactssrowiy | 1. Lack of lubrication | I. Lubricate the air motor and the | |
| impact mechanism. (See Lubrication | ||
or wiltnot impact |
| ||
| sectionof this | ||
|
| ||
| 2, Tool regulator set in | 2. Adjust the regulator on the tool to | |
| wrong position | the maximum setting | |
| 3. | 3. Adjust regulators in the air system | |
| compressor regulalor |
| |
| set too low |
| |
lmpacls rapidly but | 1. Worn impact | 1. Replace worn impact mechanism | |
components | |||
will not remove bolts mechanism | |||
| |||
Does not impact | 1. Broken impact | 1, Replace broken impact mechanism | |
components | |||
| mechanism | ||
|
| ||
Notes: