Samsung VCR8988L3K/SWS Charging, Robot manually, Main unit until you hear a Recharging power

Charging

When the product is initially purchased, the battery is fully
discharged, and you must charge the vacuum cleaning	Power lamp
robot manually.
	Charging lamp

03 OPERATING

Turn on the Power Switch at the bottom of the product.

1.After aligning the charge pins of the main unit

with the charge pin of the charger station, press	Power lamp
the main unit until you hear a Recharging power	Charging lamp
sound from the charger.

-The Charging Lamp turns green.

2.Check the charge status of the vacuum cleaning robot.

-When charging starts, “the amount of remaining battery power”

and “ ” are displayed on the status display panel in this sequence.

-When charging is complete, the battery level indicator and “FULL” will be displayed in the display panel.

Charging Fully charged

Flash

Flash

■When the battery level display fl ashes while cleaning, the vacuum cleaning robot stops vacuuming and automatically charges itself at the charger.

■If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning.

■When the battery level fl ashes and “Lo” is displayed while cleaning, vacuum cleaning robot cannot be operated by the remote control or the buttons on the main unit. In this case, directly carry the vacuum cleaning robot to the charger to charge the battery. (This is when the battery is completely discharged.)

<Charge display>

Charge Charging Required

completecharging

operating _23