13.4 Fill beans
FILL BEANS
Fill in beans as described in chapter 3.3.
The message FILL BEANS will only disappear after drawing off a coffee. We recommend cleaning the bean container from time to time with a dry cloth before you refill beans. Switch off the machine for this purpose.
13.5 Removing foreign objects
Switch off your machine by pressing ON/OFF 
key.
Remove plug from power socket.
Open bean container (13) and remove the beans. The remaining beans can be removed with a vacuum cleaner.
Loosen both screws in the bean container and then remove con- tainer (Fig. 5+6)
Remove any remaining beans with a vacuum cleaner.
Put the spanner on (Fig. 7).
Now turn spanner anticlockwise until the foreign object loosens.
Remove remaining powder with a vacuum cleaner.
Replace bean container and fasten screws.
13.6Clean machine
CLEAN UNIT
After coffee, etc., has been drawn off 220 times or after 180 rinsing programs have been run, the machine must be cleaned. You can continue to draw off coffee and hot water / steam. However we re- commend that you clean the machine (as described in chapter 14) within the next few days.
CLEAN NOW
An acoustic signal indicates the need of an immediate cleaning.
13.7 Unit calcified
UNIT CALCED
The machine signals when decalcifying becomes necessary.
Under the correct implementation of Claris filter cartridges, decalcifying of the machine becomes unnecessary. For fur- ther indications read Chapter 7 “Use of Claris filter cartrid- ges”.
13.8 Cleaning metal contacts
EMPTY TRAY
To switch off this message you need to remove calcified deposits from the metal contacts. Proceed as follows:
Rinse fastenings in groove (B) (Fig. 8) as well as the metal con-
tacts (A) with hot water and some |
| |
the fastenings in groove (B) as well as metal contacts with a |
| |
E | ||
brush. | ||
| ||
|
|
13.9 General cleaning instructions
Never use abrasive articles or corrosive chemicals to clean your machine.
Wipe down the casing inside and out using a soft damp cloth.
Clean the pivoting hot water / steam nozzle after every use.
After warming milk, draw off some hot water to clean the pivo- ting nozzle inside.
You can take off the pivoting nozzle for a thorough cleaning
The water tank should be rinsed and filled with clean water daily.
If you notice any furring in the water tank, this can be decalcified separately with a customary decalcifying agent. Remove the tank from the machine for this purpose.
15