IBM 1125, 1120 manual Without a network cable attached, 200

Page 203

A declaration of conformity with the requirements of the directives has been signed by the Director of Manufacturing and Technical Support, Lexmark International, S.A., Boigny, France.

This product satisfies the Class A limits of EN 55022 and safety requirements of EN 60950.

WARNING: When a network cable is attached, this is a Class A product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take adequate measures.

Without a network cable attached

Federal Communications Commission (FCC) Compliance Information Statement

Your printer has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly shielded and grounded cable such as Lexmark part number 1329605. Use of a substitute cable not properly shielded and grounded may result in a violation of FCC regulations.

Industry Canada Compliance Statement

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Avis de conformité aux normes d’Industrie Canada

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

European Community (EC) Directives conformity

200

Argecy Computer Corporation 248-324-1800

Page 202 Page 204
Image 203
Page 202 Page 204
Contents IBM Argecy Computer Corporation IBM Table of contents Loading the multipurpose feeder Iii Resetting the maintenance counter Ordering suppliesArgecy Computer Corporation Printer specifications 195 Argecy Computer Corporation Printer overview Standard network model configurationFully configured Menu Select 3 Return Using the operator panelUnderstanding the operator panel Menu Using the operator panel buttonsUsing the operator panel to change printer settings Menus Disabled Printing the menu settingsPrinting and deleting held jobs Using the Print and Hold functionRecognizing when format errors occur Accessing held jobs from the operator panelConfidential jobs Repeat PrintReserve Print Verify PrintMenu Select Enter PINCanceling a print job Page Curl Paper characteristicsWeight Choosing print materialUnacceptable paper Recommended paperChoosing prepunched paper Choosing preprinted forms and letterheadChoosing envelopes Choosing paperChoosing labels Choosing transparencies Choosing card stockPrint material specifications DL Envelope Universal1¾ Envelope EnvelopeShort PaperMaximum grain LongEnvelopes Labels-upper limit2Integrated forms Loading print material Loading a paper tray Loading letterhead Trouble-free printing Paper dimensionsLoading the multipurpose feeder CapacitySimplex Duplex Argecy Computer Corporation Stack height limiter Loading envelopes Loading paper and transparenciesWithout a duplex unit With a duplex unit Argecy Computer Corporation Closing the multipurpose feeder Loading the envelope feeder Argecy Computer Corporation Argecy Computer Corporation Argecy Computer Corporation Loading the 2000-sheet drawer Storing paper Tray linking Tips for avoiding paper jams Replacing the print cartridge Replacing the charge roll Replacing the transfer roll Replacing the fuser assembly Resetting the maintenance counter Ordering supplies Storing supplies Checking an unresponsive printer Identifying paper jam areas Clearing paper jams201 Paper Jam Remove Cartridge Accessing paper jam areasArgecy Computer Corporation Before reaching the output bin Paper Jam Open Rear DoorWhile exiting to the output bin Paper Jam Check Duplex Argecy Computer Corporation Interior view of duplex unit On the incline surface of a tray or between two trays 24x Paper Jam Check TrayBetween three trays Between a tray, the duplex unit, and the integrated tray Argecy Computer Corporation 2000-sheet drawer At entry into the envelope feeder Paper Jam Check Env FeederBetween the envelope feeder and the printer Argecy Computer Corporation Problem Action Solving display problemsReady Solving printing problemsJob prints from the wrong paper Material specifications for more details Solving print quality problemsDetails Job prints, but the top and side margins are incorrect Options Action Solving option problemsArgecy Computer Corporation For Novell users Solving network printing problemsResolvingquestions other problems Understanding printer messages Argecy Computer Corporation Argecy Computer Corporation Busy Canceling JobActivating Menu Changes Close Door or Insert Cartridge Check device ConnectionClearing Job Accounting Stat Deleting Jobs DefragmentingDelete All Jobs Go/Stop? Disk Corrupted Reformat? Disabling MenusEnter PIN = Disk RecoveryEnabling Menus Formatting Flash Flushing BufferFormatting Disk Insert Tray Held Jobs may be lostInfrared Network x Code InvalidLocalTalk Load ManualLoad Tray Network xy Network Card BusyNetwork Performing Self Test No Jobs Found Retry?Not Ready ParallelPrinting Directory List Power SaverPrint Jobs on Disk. Go/Stop? Prog Engine Code Printing Menu SettingsPrinting Font List Printing Job Accounting StatQueuing Deleting Jobs Prog System CodeProgram Flash Programming DiskReady Hex Queuing JobsReady Res Reduced Resetting PrinterReattach device Std Bin Full Resetting Maint Cnt ValueRestoring Factory Defaults SerialTray x Missing Toner LowTray x Empty Tray x LowDefective Print Cartridge USBWaiting 2xx Paper Jam103 Short Paper104 Res Save Off Deficient MemoryInsufficient Collation Area Insufficient Defrag Memory105 Insufficient MemoryMemory Full 106 ComplexDefective Flash Flash Full107 Software ErrorUnformatted Flash 54 Par Parallel ErrorPort x Disabled Port Disabled Std Par109 Serial Port x DisabledToo Many Disks Installed Too Many Flash OptionsDisk Full Too Many Trays AttachedIncompatible device Defective Disk111 Scheduled MaintenanceUnformatted Disk Message112 Service messageEngine Code CRC Failure 113 Using printer menus114 Pqet 115Do Not Print Finishing MenuBlank Pages 116117 CollationCopies Duplex118 Duplex BindMultipage Border 119 Multipage OrderMultipage Print 120 Multipage ViewSeparator Sheets Env Feeder Inserts envelopes as separator sheets Configure MP to CassetteSeparator Source 121122 Infrared MenuInfrared Buffer 123 Infrared PortJob Buffering Max Baud RateOff Printer does not perform NPA processing Auto NPA ModePCL SmartSwitch 124125 PS SmartSwitchTransmit Delay 126 Window Size127 Cancel JobJob Menu 128 Confidential JobHeld Jobs 129 Reset PrinterPrint Buffer 130 LocalTalk MenuLocalTalk Addr LocalTalk Zone LocalTalk BufferLocalTalk Name LocalTalk Port132 NPA Hosts133 134 Network Menu135 Network x SetupMAC Binary PS Network Buffer136 137 138 Configure MPPaper Menu Paper Cotton Paper Card Stock Labels Transparency Envelope Custom TypesEnvelope Enhance 139Duplex Paper Loading140 141 Paper SizePaper Source Smooth Normal Rough Paper Texture142 Plain Texture Preprint Texture Labels Texture143 Paper Type144 Paper WeightSubstitute Size 145 Universal Setup146 PCL Emul MenuA4 Width 147 Auto CR after LFAuto LF after CR Font NameResident Font SourceLines per 148149 OrientationPitch Point Size150 Symbol SetTray Renumber 151 Parallel MenuAdvanced Status 152 Honor Init153 Parallel ModeParallel Buffer Standard Protocol154 155 Print PS ErrorPostScript Menu Font Priority156 Quality MenuPictureGrade 157 Print ResolutionToner Darkness 1200 2400 4800 9600 19200 38400 Serial MenuBaud 158159 Data BitsHonor DSR Even Odd None Ignore Parity160 161 Robust XONRS-232/RS-422 162 RS-422 PolaritySerial Buffer Software handshaking Serial Protocol163 Hardware handshaking164 Setup MenuAlarm Control 165 Auto ContinueDisplay Language Download Target166 Jam RecoveryJob Accounting Protect225 Power SaverPrint Timeout 167168 Toner AlarmPrinter Language Resource Save169 Wait Timeout170 Utilities MenuDefragment Flash 171 Factory DefaultsFormat Disk Format FlashPrint Fonts Hex TraceJob Acct Stat Print Directory173 Print Net x SetupPrint Menus 174 USB Menu175 176 USB Buffer177 Disabling operator panel menus178 Removing options179 Removing the envelope feeder180 181 Removingunit a paper tray or duplex182 183 Removing printer or flash memory184 Removing an option cardPitch and point size Weight and styleUnderstanding fonts Typefaces and fonts186 187 Bitmapped and scalable fonts188 Resident fonts189 190 191 192 193 Symbol setsSymbol sets for PCL 6 emulation 194 Downloadable fontsPrinting a font sample list 195 Printer specificationsDimensions Duty cycle196 197 Edition notice Trademarks 198 Safety informationLicensing notice 199 Electronic emission noticesWith a network cable attached 200 Without a network cable attached201 Laser noticesUnited Kingdom Telecommunications Act Laser advisory label Laser notice202 203 Index204 205 206 207 Argecy Computer Corporation Ibmr
Top Page Image Contents