Instruction Manual | Swivel Stand |
|
|
DISPLAY PREPARATION PROCEDURES
Prepare the display for installation as follows:
1.Install the PSB bracket (shipped with the PSS) on your display according to the instructions included in PSB bracket package.
STAND ASSEMBLY PROCEDURES
Free Standing (not anchored) Applications Only:
NOTE: Do not perform this step if you are going to anchor the stand to a surface.
1.Install five rubber bumpers on the bottom of the stand (see Figure 1).
Display Measuring 30 Inches or Smaller In Height:
NOTE: Stand comes assembled for displays 30” in height or less and lowered to its minimum height for shipment.
1.Loosen the four height adjustment screws and raise the slide to its maximum height (see Figure 2).
2.Secure the slide in place by tightening the four height adjustment screws.
Display Measuring More Than 30 Inches In Height:
1.Remove the slide from the base by removing four height adjustment screws (see Figure 3).
2.Remove the front plate from the slide by removing two nuts securing the front plate (see Figure 3).
3.Install the front plate in the upper mounting holes of slide and secure using the two nuts removed in the previous step (see Figure 4).
4.Install the slide on the base using the four height adjust- ment screws (see Figure 3).
5.Raise the slide to its maximum height (see Figure 2).
6.Secure the slide in place by tightening the four height adjustment screws.
Attach rubber bumpers here
Figure 1. Free Standing Installations Only
Adjust height using these screws
Figure 2. Height Adjustment
3