Samsung DVD-R120 Setting up the Audio, Options, Audio Options, MENU, Setup, Audio, DTS, Off, Digital Output, Dynamic Compression

Setting up the Audio

Options

You can connect the DVD Recorder to an external amp or Home Theater.

Allow you to setup the Audio device and sound status depending on the audio system in use.

5 Press the …† buttons to select the desired item, then press the OK or √ button.

■Press the RETURN or œ button to return to the previous menu.

NOTE

Press the MENU button to exit the menu.

1 With the unit in Stop mode/No Disc mode, press the MENU button.

No Disc		Timer Record
Programme	Video Plus+		√
Setup	Timer Record		√
	Video Plus+ Extended : Off		√
MOVE	OK	RETURN	EXIT

2 Press the …† buttons to select Setup, then press the OK or √ button.

Audio OptionsDigital Output

1.PCM : Select this when you have no equipment that can decode Dolby Digital (or MPEG-2) signal. When you play Dolby Digital (or MPEG-2) sound track, the digital output are converted to PCM Stereo.

2.Bitstream : Output Dolby Digital (or MPEG-2) audio as bitstream. Select this when your AV receiver or AV amplifier have Dolby Digital (or MPEG-2) Decoder.

■ Digital output setting is equally applied to

Setup ystemS

No Disc		Setup
Programme	System	√
Setup	Clock Set	√
	Language
		√
	Audio	√
	Video	√

NOTE

both Dolby Digital and MPEG-2 audio. LPCM sound track is always outputted as PCM. It has no relation with Digital Output setting.

	Parental Control		√
	Install		√
MOVE	OK	RETURN	EXIT

3 Press the …† buttons to select Audio, then press the OK or √ button.

Audio setup menu will be displayed.

No Disc			Audio
Programme	Digital Output	: PCM	√
Setup	DTS	: Off	√
	Dynamic Compression	: On
			√

MOVE OK RETURN EXIT

4 Press the …† buttons to select the desired audio option, then press the OK or √ button.

No Disc			Audio
Programme	Digital Output	PCM
Setup	DTS	Bitstream
	Dynamic Compression	: On	√

MOVE OK RETURN EXIT

■Be sure to select the correct Digital Output or you will hear no sound or loud noise.

DTS

1. Off : Doesn’t output DTS signal.

Select this when your AV receiver or AV amplifier does not have DTS decoder.

2.On : Outputs DTS Bitstream via digital output when you play DTS track.

Select this only when your AV receiver (or AV amplifier) have DTS decoder.

■When DTS soundtrack is played, sound

does not output from AV Audio Output.

NOTE

Dynamic Compression

This is only active when a Dolby Digital signal is detected.

1.Off : You can enjoy the movie with the standard Dynamic Range.

2.On : When Movie soundtracks are played at low volume or from smaller speakers, the system can apply appropriate compression to make low-level content more intelligible and prevent dramatic passages from getting too loud.

English -35