Connecting & Setting Up
1.Connect Component video cables(not supplied) between the COMPONENT OUT(Y,PB,PR) jacks on
DVD Recorder and COMPONENT IN(Y,PB,PR) jacks on your TV.
2.Connect audio cables (white and red) between the AUDIO OUT jacks on the DVD Recorder and AUDIO IN jacks on TV (or AV amplifier).
(See pages 20 to 21).
●Press the input selection on your TV remote control until the Component signal from the DVD Recorder appears on your TV screen.
3.After connecting, refer to the page 34 to 36.
●You will enjoy high quality and accurate colour reproduction images.
COMPONENT | green | red | blue | green |
|
|
|
| |
Y |
| 1 |
|
|
| blue |
|
| |
|
|
|
| |
Pb |
|
|
|
|
| red |
|
|
|
Pr |
|
|
|
|
Other type of connecting the Audio output cable
There are several ways to output audio signal not using scart cables. Select the audio connection that best suits you below.
●Case 1 : Connecting to your TV
●Case 2 : Connecting to a stereo amplifier with AV output jacks
●Case 3 : Connecting to an AV amplifier with a digital output jack
Manufactured under license from Dolby Laboratories. “Dolby” and the
“DTS” and “DTS Digital Out” are trademarks of Digital Theatre Systems, Inc.
If your TV has audio input jacks, use this connection.
■The Component jacks will not output video resolutions above 576p.
To view 720p and 1080i connect the DVD Recorder to your TV with the supplied HDMI cable.
With HDMI connected, press the P.SCAN button to alternate between all available resolutions.
(See page 35)
■ Make sure that the colour coded
| connections match. The Y, PB, PR | |
NOTE | ||
component output jacks of your DVD | ||
| ||
| Recorder must be connected to the exact | |
| corresponding component input jacks on | |
| your TV. |
■Progressive setting is only available when the Video Out is set to Component.
(See pages 35~36)
yellow
white
red
red | white | yellow |
20- English