Operating the cleaner
Installing the robotic vacuum cleaner
Installation order
1.Turning the Power Switch on or off
To use the robotic vacuum cleaner, you must turn on the Power Switch at the bottom of the main unit.
2.Installing the Charger
To charge the robotic vacuum cleaner, you must first install the charger.
Since the battery is discharged when the product is purchased, you must fully charge the battery before use.
3.Charging the Battery
You should charge the battery completely before using the robotic vacuum cleaner.
4.Installing the VIRTUAL GUARD
You can confine the robotic vacuum cleaner to a particular section by using Fence (virtual wall) mode or clean several sections one by one using Guard (virtual door) mode.
Turning the Power Switch on or off
To use the robotic vacuum cleaner, you must turn the
Power Switch on.
If you turn the Power Switch off, all settings will be reset.
1. Turn over the main unit and turn the Power Switch on.
-If the icons are not turned on, it indicates that the battery charge is depleted. In this case, dock the robotic
vacuum cleaner to the charger station after turning the Power Switch on.
- Note that turning the Power Switch off will reset all settings.
-When no key is pressed for approximately 10 minutes
when the power is on, the power is automatically turned off to save battery power. In this case, to use this robotic vacuum cleaner again, please push the "Power" button or "Start/Stop" button.
If the Power Switch is turned off, the robotic vacuum cleaner will not be charged CAUTION even if it is docked with the charger station.
20_ Operating the cleaner