Linear EXA-1000 manuals
TV and Video > TV Antenna
When we buy new device such as Linear EXA-1000 we often through away most of the documentation but the warranty.
Very often issues with Linear EXA-1000 begin only after the warranty period ends and you may want to find how to repair it or just do some service work.
Even oftener it is hard to remember what does each function in TV Antenna Linear EXA-1000 is responsible for and what options to choose for expected result.
Fortunately you can find all manuals for TV Antenna on our side using links below.
1 pages 97.67 Kb
1 EXA-1000The EXA-1000Remote Antenna is designed to enhance the radio STEPIdentify Parts. Lay out and identify all Identify Partsrange of Linear’s receivers. This antenna can be connected to PARTS LISTthe parts as shown. Check the parts list to be sure allthe “F” connector on many Linear receivers to improve their range items were included in the kitwhen they must be located in poor signal reception locations ITEM # DESCRIPTIONUsually an increase of 20-30%range can be expected. The Remote Antenna withversatile EXA-1000can be mounted in a variety of ways. A 2-inch 5-Foot RG-59/U Co-axCableU-boltis supplied for post or pipe mounting, or the U-boltholes Vertical Radialsin the Base Plate can be used to screw the antenna to a wall Base Plate (3" x 3" x 1")or vertical wood brace or beam 4 Radials (9-3/8"Stainless Steel)☞ NOTE: Generally, the higher the antenna is mounted above ground level, the better the radio range will be 2-56Hex Nuts for Radials (4)The EXA-1000provides maximum performance when mounted Installation2" Diameter U-Boltand installed properly according to these instructions. Please Instructionsread the entire instructions beforebeginning any work.The The 1/4" Internal Star Washers for U-BoltEXA-1000is a 1/2 wave, center fed, vertical antenna composed of three parts: an Antenna assembly with “F” connector 7/16" Hex Nuts for U-Boltattachment; a Base Plate radial mounting provisions; and a five-foot, 75-ohmcoaxial cable. The cable Antenna (9-1/4"Stainless Steel)connects to the antenna base on one end and the receivers “F” 1/2" Hex Nut for Barrel Connectorconnector on the other. If the antenna must be mounted further than five feet from the receiver, an extension cable of up to a 1/2" Flat Washer for Barrel Connectormaximum of 25 feet may be used instead of the five foot cable supplied. Because of the cable resistance, the performance of F-81Barrel Connectorthe EXA-1000may be degraded by using longer than a 25 foot cable
Also you can find more Linear manuals or manuals for other TV and Video.