280-7323-00

5DMX5555z 6DMX5555z DMX5555z 7

4. NOMENCLATURE
Note:
Be sure to read this chapter referring to the front diagrams of chapter 3. CONTROLS on page 5 (unfold).
3.CONTROLS / LES COMMANDES / CONTROLES
Source unit / Appareil pilote / Unidad fuente
Note: Be sure to unfold this page and refer to the front diagrams as you read each chapter.
Remarque: Veuillez déplier cette page et vous référer aux schémas quand vous lisez chaque chapitre.
Nota: Cuando lea los capítulos, despliegue esta página y consulte los diagramas.
Display / Afficheur / Visualizador
1Preset buttons (1 to 6)
Direct buttons (1 to 6) (7 to 12)
2Z-EHCR (z-enhancer) button
3DISP (display) button
4SPE-ANA (spectrum analyzer) button
5SCN (scan) button
PS/AS (preset scan/auto store) button
6RPT (repeat) button
7POWER button
FUNC (function) button
8RDM (random) button
9ISR (instant station recall) button
0MUTE button
!BAND (band) button
TOP button
1CD IN indication
2SINGLE indication
3ST (stereo) indication
4SCN (scan) indication
5RPT (repeat) indication
6RDM (random) indication
7Operation status indication
The frequency, play time, clock, etc. are
displayed.
8CD/MD changer indication
9Title scroll indication
0MD IN indication
!MANU (manual) indication
@LD (loudness) indication
#A-M (audio mode) indication
$Function mode indication
The names of modes being selected, etc. are
displayed.
%Preset channel indication (1 to 6)
Disc number indication (1 to 12)
The disc numbers corresponding to the discs
in the CD or MD changer light.
¥Z-EHCR (z-enhancer) indication
&DISC indication

Names of Buttons

¡)345678 90 !@#$%*¥&(1123456 7 89 0&¥%$# @!
@ENT (enter) button
Play/pause button
#TITLE button
ADJ (adjust) button
$MD EJECT button
%Left button
¥Right button
&Up button
*Down button
(A-M (audio mode) button
LOUD (loudness) button
)CD EJECT button
¡CD insertion slot
MD insertion slot

Display Items

Inserting the Batteries

1. Turn the remote control unit over, then slide
the rear cover in the direction of the arrow.
2. Insert the AA (UM-3/1.5V) batteries that came
with the remote control unit facing in the di-
rections shown in the figure, then close the
rear cover.
Notes:
Using batteries improperly can cause them to ex-
plode. Take note of the following points:
When replacing batteries, replace both batteries
with new ones.
Do not short-circuit, disassemble or heat batter-
ies.
Do not dispose of batteries into fire or water.
Dispose of spent batteries properly.
5. REMOTE CONTROL
Remote control unit
Receiver for remote control unit
Signal transmitter
Operating range: 30° in all directions
£
;
ª¤§¢º
Rear side
AA (UM-3/1.5V)
Batteries
Rear cover
2