3Com 3CR990SVR95 Changing NetWare Driver Configuration Parameters, Log in or map to the server

Changing NetWare Driver Configuration Parameters 103

2Log in or map to the server.

If you cannot log in or map to the server, the link is not functional.

If the link is functional, the following message appears:

Link integrity test for primary slot #XXXXX passed.

Changing NetWare Driver Configuration Parameters

You can change server configuration parameters using the NetWare installation program Configuration screen. The following table lists the parameters shown on the Configuration screen. Default values are shown in uppercase text.

Table 2 NetWare Installation Program Configuration Parameters

Parameter	Range of Values	Description
Slot Number	All PCI slot numbers valid	Represents the PCI slot number of
	to the system	the physical NIC to be configured.
Node Address	Default is factory-assigned	Leave blank to use
	MAC address.	factory-assigned default.
ENABLE_CHKSUM	Enable	NetWare 5.0 only. Enter the
	DISABLE	parameter on the load line to
		enable TCP/IP checksum offload.
		Do not enable TCP/IP checksum
		offload if you plan to form load
		balancing/failover groups.
SHD_LEVEL	None	Basic—Monitors levels for the
	Basic	following self-healing driver
		conditions: firmware heartbeat,
	ENHANCED
		interrupt availability, recoverable
	Basic + Enhanced	transmit and receive errors (CRC,
		transmit underruns, receive
		overruns, collisions, jabbers).
		Enhanced—Monitors DMA stalls
		and hardware errors.
VERBOSE	Enable	Enables driver warning and error
	DISABLE	messages.