3D Connexion LST42B 17

CABLE OPERATED MANUAL ATTACHMENT CLUTCH

STEP 35: (SEE FIGURE 35)

•Attach the two suspension arms to the rear of the clutch/idler assembly using two 5/16" x 3/4" hex bolts (C), 5/16" washer (Q) and 5/16" nylock nuts (Y) for each arm. Place the arms on the outside of the frame with the notches to the rear.


5/16" NYLOCK		5/16" x 3/4"
NUT (Y)	5/16" WASHER (Q)	HEX BOLT (C)

FIGURE 35

STEP 36: (SEE FIGURE 36)

•Assemble the cable bracket to the clutch/idler assembly using two 5/16" x 3/4" carriage bolts (K) and 5/16" nylock nuts (Y). Use the two front holes in the cable bracket if your tractor has a 42" mower deck. Use the two rear holes if your tractor has a 46" mower deck.

5/16" x 3/4"

CARRIAGE BOLT (K)

CABLE

BRACKET

46" 42"

DECKS DECKS

5/16" NYLOCK

NUT (Y)

FIGURE 36

STEP 37: (SEE FIGURE 37)

•Two different length drive belts are included with your snow thrower. Tractors with manual attachment clutches and dual front deck suspension brackets use the 55" drive belt with #46989 printed on the outside of the belt. DO NOT USE the other belt.

•Slightly loosen the hex bolt next to the ﬂ at idler pulley. Install the drive belt down between the hex bolt and the

ﬂat idler pulley with the ﬂ at side of the belt against the pulley. Retighten the hex bolt.

Loop the belt around the large v-pulley, placing it between the v-pulley and the hex bolt next to the pulley.

HEX BOLTS	FLAT IDLER
	PULLEY

(#46989)

DRIVE BELT

FIGURE 37

Did you choose the correct drive belt for STOP your tractor? Using the wrong length belt

may cause premature bearing or belt failure.

STEP 38: (SEE FIGURE 38)

•Move the attachment clutch lever on the dash panel to the disengaged (down) position.

•Place the clutch/idler assembly on the ﬂ oor on the right side of the tractor.

•Attach the tractor's clutch cable to the cable bracket. Secure the cable housing guide (groove down) to the cable bracket using the original collar and a 5/64" hair cotter pin (DD).

•Place a spacer (LL) on the welded pin on the idler arm. Hook the end of the clutch spring over the pin and secure it with a 1/4" washer (P) and a 5/64" hair cotter pin (DD).

5/64" HAIR COTTER PIN (DD)

1/4" WASHER (P)

SPACER (LL)

TRACTOR'S CLUTCH CABLE

5/64" HAIR COTTER PIN (DD)

FIGURE 38