24

SECTION 3

OPERATION

CAUTION

In case of power failure, turn all switches to the “OFF”
("O")positionandremovetheproduct.Afterthepower
has been restored, perform the normal startup pro-
cedure. IF THE OVEN WAS SWITCHED OFF FOR
LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE
MINUTES BEFORE RESTARTING THE OVEN.
A.Daily Startup Procedure
3. Turnthe"CONVEYOR"
() switch to the “ON”
("I")position.
4. If necessary, adjust the
conveyor speed setting
by pressing the or
pushbuttons on the
conveyor speed controller
to change the displayed
bake time.
6. Turnthe "HEAT" ( )
switchto the "ON" ("I")
position, and wait for the
"HEATON"light to turn
on.
8. (Optional) Press the Tem-
perature ( ) key to show
the Actual Temperature
in the display, and wait
forthe"ACTUALTEMP"
light to turn on. This allows
you to monitor the oven
temperature as it rises to
the setpoint.
1. Turn the "HEAT" (
) and "BLOWER" (
)swit-chesto the"OFF"
("O")position.Notethat
the blowers will remain in
operation until the oven
hascooledtobelow200°F
(93°C).
IV. NORMAL OPERATION - STEP-BY-STEP 7. Wait for the oven to heat to the setpoint temperature.
Highersetpointtemperatures will require a longer wait.
Theovencan reachatemperatureof 500°F(232°C)in
approximately15minutes.
3. After the oven has cooled and the blowers have turned to
the “OFF” or “O” position, switch the circuit breaker/fuse
disconnect to the “OFF” or “O” position.
2. Make certain that there
are no products left on the
conveyor inside the oven.
Turnthe"CONVEYOR"(
)switchtothe"OFF"
("O")position.
2. Turnthe"BLOWER"
() switch to the
“ON”("I")position.
• PresstheUpArrow
and Down Arrow
Keys as necessary to
adjust the set-point.
5. Adjust the temperature
controller to a desired set
temperature, if necessary.
• PresstheSet Point
and Unlock keys at
the same time. Wait
forthe"SETPT"light
to turn on.
B. DAILY SHUTDOWN PROCEDURE
9. Allow the oven to preheat for 10 minutes after it has reached
the set point temperature.
++
wait
for
or
wait
for
or
wait
for
1. Check that the circuit breaker/fused disconnect is in the
on position.

IMPORTANT

Ongasovens,ifthe"HEATON"lightwillnotilluminate,OR
if the oven does not heat, the gas burner may not have lit.
Turnthe"HEAT"( ),"BLOWER"( ),and"CONVEYOR"
()switchestothe "OFF"("O")position.Wait for AT
LEAST FIVE MINUTES before restarting the oven. Then,
repeat the Daily Startup procedure.