INSTRUCTIONS FOR ASSEMBLY AND FITTING

For further information concerning assembly and fitting, call 3M OH&ESD Technical Service

Cartridge (Figure 8)

fig. 8

1.Screw the cartridge into the facepiece inhalation port. This port is found on the right hand side, as you are looking at the front of the facepiece.

2.When the cartridge first contacts the inlet port gasket, tighten the cartridge up to an extra 1/4 turn to insure a tight, leak free seal.

Left/Right Cartridge Conversion (Figures 9-11)

fig.9

fig. 10

fig. 11

1.Remove cartridge from the facepiece by unscrewing counter clockwise.

2.Grasp the inhalation valve body seat at the two tabs that stick out away from the facepiece, and pull straight away until it is unseated from the side port.

CAUTION

Do not pull on the spokes of the inhalation valve body seat as this may break the spokes and require replacement of the inhalation valve kit

3. Set aside the inhalation valve assembly on a clean surface for later installation.

9