36
Multifunctional settings
OPTION Menu
Item Description
AUTO SEARCH
Using the buttons ▲/▼ turns on/off the automatic signal search function.
TURN ON TURN OFF
This function works with INPUT, RGB, and VIDEO buttons.
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in the following order. The search is
started from the current port. Then when an input is found, the
projector will stop searching and display the image.
RGB IN1 RGB IN2 COMPONENT VIDEO S-VIDEO VIDEO
AUTO OFF
Using the buttons ▲/▼ adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes) Short (min. 0 minute = DISABLE)
AUTO OFF
ENABLE
1
AUTO OFF
DISABLE
0
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with no-
signal or an unsuitable signal reaches at the set time, the projector
lamp will go off and the power indicator begins blinking. Please
refer to the section “Turning off the power” (16).
LAMP TIME
The lamp time is the time counted after the last resetting. It is
shown in the OPTION menu as the usage time of the lamp.
Pressing the RESET button on the remote control or the button ►
of the projector displays a dialog. To reset the lamp time, select the
RESET using the button ▲.
RESET CANCEL
• Please reset the lamp time only when you have replaced the lamp,
for a corresponding message about the lamp.
• For the lamp replacement, see the section "Lamp" (38, 39).
FILTER TIME
The filter time is the time counted after the last resetting. It is shown
in the OPTION menu as the usage time of the air filter.
Pressing the RESET button on the remote control or the button ►
of the projector displays a dialog. To reset the filter time, select the
RESET using the button ▲.
RESET CANCEL
•
Please reset the filter time only when you have cleaned or replaced
the air filter, for a corresponding message about the air filter.
• For the air filter cleaning, see the section "Air filter" (40).
With the OPTION menu, the items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the projector or
remote control, and press the cursor button ► on the projector
or remote control, or the ENTER button on the remote control to
execute the item, except for the items LAMP TIME and FILTER
TIME. Then perform it referring to the following table.
MENU [RGB]
PICTURE
:SELECT
IMAGE
SETUP
INPUT
OPTION
EASY MENU
SCREEN
AUTO OFF 0
LAMP TIME 0
FILTER TIME 0
AUTO SEARCH TURN OFF
SERVICE