LOADING PAPER

__________________________________________________________________

HOW TO LOAD THE PAPER

This register uses standard 2 1/4" single ply calculator paper to produce either a customer receipt (outside) or a journal record (inside).

NOTE: It is recommended to use ROYAL brand 2 1/4" (57mm) "bond quality" paper which will help prevent dust deposits on the printer mechanism caused by inexpensive paper rolls. Replace with standard bond quality calculator paper. ROYAL Order #013129.

1.Plug in your cash register.

2.Grasp the printer cover and pull gently up. Remove the printer cover and set aside. (Figure E)

3.Cut or tear the end of the paper roll evenly for a straight edge to permit proper feeding through the printhead.

4.Place the paper roll in the paper holder so that the paper will feed out from the bottom of the roll.

5.Insert the end of a single paper tape into the paper slot. (Figure F). Adjust writing table as needed to insert the paper.

6.Depress the paper feed [Feed] key until the paper catches and advances through the printer.

7.If the paper does not feed through the printer, make sure the paper was entered properly.

8.Pass the tape through the receipt window of the printer cover.

or

If a journal record is desired, insert the tape into the journal winder. Simply advance the tape approximately 10-12 inches by using the paper feed [Feed] key. Then, slide the tape under the two forks that extend on both sides of the journal winder. (See Figure H). Turn the spindle manually a few times to take up the excess paper. Then advance the paper using the Feed key until the journal paper winds securely around the spindle. (Figure H]

9.Replace the spindle and close the printer cover.

10

abcoffice www.abcoffice.com 1-800-658-8788