Installing the Mylex Disk Array Controller as the Primary Windows 2000 Controller
4.When prompted for the Manufacturer’s supplied hardware support disk, insert your Mylex Windows 2000 Drivers Software Kit diskette into the floppy disk drive and press <Enter>.
You will see a screen with the following information:
You have chosen to configure a SCSI Adapter for use with Windows 2000, using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC to return to the previous screen.
5.Use the scroll bar (if available) to locate and select one of the following devices:
Mylex AcceleRAID 160 Disk Array Controller1 Mylex AcceleRAID 170 Disk Array Controller Mylex AcceleRAID 352 Disk Array Controller Mylex eXtremeRAID 2000 Disk Array Controller Mylex eXtremeRAID 3000 Disk Array Controller
6.With the Software Kit diskette still in the floppy disk drive, select your controller and press <Enter>. The driver will load and the installation program will ask you if you want to install any additional drivers.
7.If you have drivers to install for other controllers (for example, an
If you have no other drivers to install, or when you have finished installing other drivers, simply press <Enter> to continue installation.
If you installed other drivers from other diskettes, you will be asked to reinsert those diskettes as well.
8.Finally, you will be prompted to remove any diskettes and
This concludes Mylex Disk Array Controller driver installation for Windows 2000 when using eXtremeRAID 2000, eXtremeRAID 3000, AcceleRAID 160/170LP, AcceleRAID 170, or AcceleRAID 352.
Please continue with the Microsoft Windows 2000 Installation Procedure.
1. Important: Select this device for the AcceleRAID 170LP also.
PCI Disk Array Controller Drivers Manual |