Page 1 of 3
X.25 PORT CONFIGURATION
Summary: Use this procedure to set several parameters that must be set before using the X.25 interface. Table
Data Link Layer LAPB Parameters
The Soneplex Broadband system data link layer uses the standard Link Access Procedure Balanced (LAPB) protocol. Parameters supported, set values, configurable options, and defaults are shown in Table
Network Layer X.25 Packet Parameters
The Soneplex Broadband system now supports three Virtual Circuits, including two Permanent Virtual Circuits (PVCs) (each assigned to a separate TL1 or Craft interface), and one Switched Virtual Circuit (SVC). The X.25 interface operates only on Port 3. The PVC ID default assignments are shown in Table
Other Network Parameters
Other supported network parameters, set values, configurable options, and defaults are shown in Table
Note: Edits can be made in the configuration database in one of two ways: 1) If the complete field is highlighted, use the space bar to toggle forward or the “R” key to reverse toggle through the options for that field. 2) If only the first space or the field is highlighted, type in the data that applies to that field.
Note: Edits to the configuration database can be saved after each change in one of two
ways: 1) by pressing an arrow key and then the Enter or Return key once; or 2) by pressing the Enter or Return key twice after all selections and entries are made in the screen but before leaving the screen.
Note: Press
1.Use the arrow keys to select System Configuration from the Main Menu. Press Enter or Return.
2.Select X.25 Configuration and press Enter or Return. An X.25 Configuration screen is shown in Figure
3.Use the arrow keys to move to each toggle field, and the space bar to make each selection. X.25 Configuration field defaults and options are listed in Tables
© 2000, ADC Telecommunications, Inc.