2. Installation Mounting an ADT-APS-6R in a ADT-CAB-400AA Backbox

10 ADT-APS-6R Instruction PN 50935:B 7/21/00
Mounting an ADT-APS-6R in a ADT-CAB-400AA Backbox

An Auxiliary Power Supply is mounted as shown in the figure below.

To mount the ADT-APS-6R, follow these instructions:

Figure 4 Mounting an ADT-APS-6R to a ADT-CAB-400AA Backbox
Step Action
1 Remove plastic cover from APS-6R.
2 If 240 VAC is to be used, cut JP1 jumper at this time. See "Configuring the
ADT-APS-6R" on page 16.
3 Place the APS-6R onto the mounting studs in the backbox.
4 Insert a standoff through each of the printed circuit board mounting holes,
threading each standoff to the mounting studs.
5 Tighten the standoffs until the APS-6R is securely fastened to the backbox.
6 Reinstall the plastic chassis cover.
Standoff
(2 places)
ADT-APS-6R
Assembly
ADT-CAB-400AA
Backbox
Mounting
Studs
APS-6R to CAB-AA.cdr
ADTAPS-6R__INSTENGLB0.fm Page 10 Tuesday, November 21, 2000 11:30 AM