EKI-7758F User Manual 110
C.2 Port C.2.1 Port Statistics
The following information provides the current port statistic information.
• Port: The port number.
• Type: Displays the current speed of connection to the port.
• Link: The status of linking—‘Up’ or ‘Down’.
• State: It’s set by Port Control. When the state is disabled, the port will not transmit or
receive any packet.
• Tx Good Packet: The counts of transmitting good packets via this port.
• Tx Bad Packet: The counts of transmitting bad packets (including undersize [less
than 64 octets], oversize, CRC Align errors, fragments and jabbers packets) via this
port.
• Rx Good Packet: The counts of receiving good packets via this port.
• Rx Bad Packet: The counts of receiving good packets (including undersize [less
than 64 octets], oversize, CRC error, fragments and jabbers) via this port.
• Tx Abort Packet: The aborted packet while transmitting.
• Packet Collision: The counts of collision packet.
• Packet Dropped: The counts of dropped packet.
• Rx Bcast Packet: The counts of broadcast packet.
• Rx Mcast Packet: The counts of multicast packet.
• Click ‘Clear button to clear the information.
Figure C.32: Port Statistics
C.2.2 Port Control
In Port control, you can view every port status that depends on user setting and the
negotiation result.
• Port No.: select the port that you want to configure.
• State: current port status. The port can be set to disable or enable mode. If the port
setting is disable then will not receive or transmit any packet.
• Speed/Duplex: set the port link speed.
• Duplex: set full-duplex or half-duplex mode of the port.
• Flow Control: set flow control function is Symmetric or Asymmetric in Full Duplex
mode. The default value is Symmetric.