Agilent Technologies 664xA, 665xA, 667xA, 668xA, AGILENT Model 6653A: 3145A-00551, Model 6641A: 3217A-00111, Model 6645A: 3215A-00111, Model 6651A: 3130A-00171, Model 6652A: 3201A-00381, Model 6654A: 3148A-00391, Model 6655A: 3152A-00176, Model 6671A: 3129A-00218, Model 6672A: 3138A-00101, Model 6673A: 3138A-00101, Model 6674A: 3133A-00161, Model 6675A: 3138A-00101, Model 6680A: 3302A-00101, Model 6681A: 3250A-00101, Model 6682A: 3339A-00101, Model 6683A: 3339A-00161, Model 6684A: 3339A-00101

Installation 46

Installing the Power Cord

Installation of the power cord must be done by a qualified electrician and in accordance with local

electrical codes.

The power cord supplied with power supply may or may not include a power plug (see "Options" in Chapter l) at one end of

the cord. Terminating connections and a ground lug are attached to the other end of the cord.

See Figure 2-2 and proceed as follows:

1. If they are not already in place, position the strain relief connector ), safety cover , rubber boot , and

connector nut on the power cord .

2. Secure the ground wire to the chassis earth ground stud.

3. For single-phase operation, connect the neutral wire to the N input terminal and the line wire to the L input

terminal (this line is fused inside the supply).

4. For line-to-line operation from a three-phase source as shown in Figure 2-3, connect one phase to the N input

terminal and another phase to the L input terminal (this line is fused inside the supply).

Note The N terminal is not internally grounded.

5. Position the safety cover over the power input terminals and tighten the cover screws and strain relief connector

screws .

Figure 2-2. Connecting the Series 667xA Power Cord