102 Index
D
declaration of conformity,9
detecting error conditions,46
device type register, reading,91
DISPlay MONitor CARD,58
DISPlay MONitor CARD?,59
DISPlay MONitor STATe,59
DISPlay MONitor STATe?,60
DISPlay subsystem,58
documentation history,8
E
E1442A command reference,51
error conditions, detecting,46
error messages,99–100
error types,99
examples
Advancing Scan Using TRIGger,79
Check Device Driver,39
Closing Form C Switch Channels,67
Common Terminal Pullup Configuration,32
Differential Divider or Filter Configuration,36
Divider with Filter Configuration,35
Enable the Status Register,74
Enabling Continuous Scans,62
Enabling the Monitor Mode,60
Enabling Trig Out Port,64
Error Checking Using Interrupts,47
Error Checking Using Polling,46
Low-Pass Filter Configuration,31
Normally Closed Terminal Pullup Config,33
Normally Open Terminal Pullup Configuration,34
Open, Close, and Scan Operations,40
Opening Form C Switch Channels,68
Query Continuous Scanning State,62
Query Form C Switch Channel Closure,67
Query Form C Switch Channel Open State,68
Query Module Identity,40
Query Number of Scanning Cycles,57
Query the Operation Status Enable Register,74
Query Trig Out Port,64
Query Trigger Source,81
Reading a Card Description,76
Reading Card Model Number,77
Reading the Error Queue,78
Reading the Operation Status Register,75
Register-Based Programming,96
Resistor Divider Configuration,30
E (continued)
examples (cont’d)
Scanning Using Bus Triggers,81
Scanning Using External Devices,69
Scanning Using External Triggers,81
Scanning Using Trig Out and Trig In Ports,49
Scanning With External Device,48
Select Module #2 for Monitoring,58
Set Power-On State,77
Setting a Logical Address,18
Setting Ten Scanning Cycles,56
Starting a Single Scan,62
Stopping a Scan with ABORt,55
Straight-Through Configuration,29
Synchronizing the Form C Switch,50
System Error Checks,41
Using the Scan Complete Bit,45
I
ID register, reading,91
IEEE 488.2 commands reference,83
implied commands,52
INITiate CONTinuous,61
INITiate CONTinuous?,62
INITiate IMMediate,62
INITiate subsystem,61
installing the switch,23
internal buses, setting,21
interrupt priority, setting,20
L
logical address, setting,18
O
offset, register,89
Option 010 terminal module,27
OUTPut ECLTrgn STATe,63
OUTPut ECLTrgn STATe?,63
OUTPut EXTernal STATe,64
OUTPut EXTernal STATe?,64
OUTPut subsystem,63
OUTPut TTLTrgn STATe,65
OUTPut TTLTrgn STATe?,65
P
parameters,53
programming the switch,37
programming, register-based,87