ASSEMBLY
TO REMOVE UNIT FROM CARTON
•Cut from top to bottom all four corners of the carton and lay panels flat. (See Fig. 1)
•Remove the lag screw that holds the floating hitch to the packing skid.
•Disassemble and discard carton's wood top and side supports.
•Remove four hex bolt, hex nuts and flat washer from the hold down brackets at the rear of the carton.
•Remove and save the two Flat Washers and Cotter Pins from the rear axle. Reuse when attaching gauge wheels.
•Discard all other packing hardware and hold down brackets.
TO INSTALL THE TILLER GAUGE WHEELS
•Assemble Gauge Wheels onto the Rear Axle with the extended end of Hub facing inward. Secure with the Flat Washers and Cotter Pins which you removed from the axle during unpacking. (See fig. 2.)
FIG. 1
•Right hand (RH) and left hand (LH) are determined from the drivers position while seated on the tractor.
•We recommend that you remove the Mower Deck before using the Tiller. Refer to your Tractor Owner's Manual.
FIG. 2
TO INSTALL THE TILLER TINE ASSEMBLIES
•Attach the floating hitch to the tractor's draw bar.
(Refer to Operating Instructions on page 7.)
•Remove the preassembled 3/8" x 2" hex bolt and 3/8" nylock nut from the L.H. Tine Assembly. Slide the tine assembly onto the Transmission Axle on the left side of the tiller and secure with the hex bolt and nylock nut.
(See fig. 3.) Repeat for the R.H. side.
3/8" NYLOCK NUT
4
FIG. 3