CUSTOMER RESPONSIBILITIES

CLUTCH CABLE ADJUSTMENT

INNER NUT

• Remove four screws from Rear Drive Cover. Lay aside cover and screws.

• Place Clutch Lever in “DISENGAGED" position

• The Cable should be under slight tension but should not pull the Clutch Lever more than 1/8" away from the Switch Body.

NOTE: If the Plunger extends more than 1/8" out from the switch body, the cable tension is too tight and the

OUTER NUT Engine will not start.

SWITCH

BODY

1/8"

PLUNGER

CLUTCH LEVER

FOUR SCREWS

REAR DRIVE

COVER

TO INCREASE CABLE TENSION

•Place Blade Clutch Lever in the “DISENGAGED" position.

•Loosen the inner nut on the Clutch Cable.

•Tighten the outer nut on the Clutch Cable.

TO DECREASE CABLE TENSION

•Place Blade Clutch Lever in the “DISENGAGED" position.

•Loosen the outer nut on the Clutch Cable.

•Tighten the inner nut on the Clutch Cable.

•Repeat the above procedure until you have the correct tension.

 

IDLER

ENGINE

PULLEY

 

PULLEY

 

BLADE

 

PULLEY

 

CLUTCH LEVER

19