While performing the assembly operations instep11,makesurethecartbagisbetween the top angle support and the cart.
11.Place the top angle support and cart bag ontop of the cart as shown in figure 27. Then, using a screwdriver or other sharp object, poke holes through the cart bag for the bolts that will be assembled in step 12.
12.Attach the top angle support and braces to the cart using seven 1/4" x 3/4" hex bolts, fourteen 5/16" washers (one placed on each side) and seven 1/4" nylock nuts. DO
NOT TIGHTEN YET. See figure 27.
NOTE: Cart bag not shown for clarity.
13.Slide each end of the rope through the holes in the tailgate shown in figure 28.
14.Tie a knot in the end of each side of the rope to secure the rope in place. Keep knot loose. See figure 28.
HINT: Knot may need to be moved up or down in rope to secure tailgate. See step 18 for more information.
15.Slide tailgate into tailgate guides.
16.Attach clips to 3rd lower support rod and fasten them to the tailgate using two #10 x 5/8" slotted head bolts and #10 nuts. See figure 28.
17.TIGHTEN all bolts assembled in steps 7 through 12.
18.Secure tailgate rope around the bolts shown in figure 28. If rope does not keep tailgate held down or rope is too short to secure around bolts, move the knot up the end of the rope to loosen or down to tighten. Once knot is in desired location, tighten the knot to secure it in place.
1/4" x 3/4"
HEX BOLT
1/4"
WASHER
1/4"
WASHER
1/4" x 1"
HEX BOLT
1/4"
NYLOCK
NUT
NOTE: Cart bag not shown for clarity.
TRUSS BOLT
CLIP |
|
| |
| NYLOCK |
KNOT | NUT |
|
ROPE
SECURE
ROPE
FIGURE 28
FIGURE 27
13