© 2004 Alamo Group Inc.
SAFETY
SAFETY
47730
Do not handle round bales or large
objects unless loader is equipped
with proper attachments.
Operate loader only with approved
hydraulic valves.
Failure to comply may result in
serious injury and/or death.
Failure to comply may result
in serious injury or death.
Do not lift or carry anybody in
loader or work from bucker or any
other attachment.
Handle raised loads with caution.
Carry loads low.
WARNING
WARNING
48921
DANGER
Failure to comply may result in
serious injury or death.
Use ROPS and seatbelt at
all times.
Add recommended rear
ballast.
Operate tractor at low speeds.
WARNING
TO AVOID INJURY
DURING REMOVAL
OR REINSTALLATION
OF LOADER
Read and
understand
instructions in
operator’s manual
Failure to follow above
instructions can cause
serious injury.
Make sure detached loader
is parked on hard, level
ground.
Always have a bucket
mounted to loader when it
is removed from tractor.
Do not permit bystanders
within 10 feet of loader.
Do not remove bucket or
repair loader if it is not
mounted on tractor.
Failure to comply could
cause loader to collapse.
51902
48434
DANGER
Do not walk or work under a
raised loader.
Lower loader to ground
when parked.
Failure to comply may result
in serious injury and/or death.
Keep bucket and boom away
from overhead electric lines.
Failure to comply will result in
serious injury or death.
48858
DANGER
WARNING
LOADER SAFETY
Know all operation,
warning and safety
instructions in the
operator’s manual
before operating the loader.
(Replacement manuals are
available from your dealer.)
Failure to follow any of
the instructions above
can cause serious injury
to the operator or other
persons in are.
Operate loader only from
operator’s seat.
Carry bucket low during
transport for better visibility
and to avoid overturns.
Use wheel ballast and / or
rear weight for stability as
recommended in the
operator’s manual.
When parking or servicing
unit, lower the bucket to the
ground, stop engine, and
set the parking brake to
avoid tractor movement.
46776
48322
TO SUPPORT
LOADER ARMS
Raise loader, place
loader support onto
left cylinder rod and pin.
Slowly lower loader until
support takes the load.
TO REMOVE SUPPORT
Raise loader, remove pin, and
support, then store.
DANGER
Loader support must be
installed prior to working
under raised loader. Failure
to comply may result in
serious injury or death.
WARNING
When the loader is mounted to
a tractor with SuperSteer
™
,
the bucket will shift in
the opposite direction
from which the
front wheels are turned.
Maximum shift will be approximately
8 inches and most noticeable when the
tractor is stationary.
Failure to heed this warning can result
in serious injury to the operator or
other persons.
46779
F-3778-12-04 Safety Section 1-10