Using the HDD PortaCruiser

Duplicator Mode

Main Menu: Copy HDD

The “Copy HDD” function performs an actual copy from the source HDD to the target HDD. The target HDD must be at least as large as the source. The HDD PortaCruiser will copy every block of capacity on the source HDD.

1.Load the source HDD and the target HDD into the HDD PortaCruiser. The system will auto-detect the hard drives. After the drives have been detected, a screen similar to the one below will be displayed.

1. Copy HDD

ENT RESET

149.1GB

ESC MUTE

Note: Before copying be sure that the capacity of the target HDD is equal to or larger than the source hard drive.

2.Press ENT to start copying. The system will auto-detect the hard drives. The following information will be displayed.

Detect Drives

Please wait...

ENT RESET

ESC MUTE

3.During the copy process the HDD PortaCruiser will display progress information.

Copy - 36MB/s 0%

235.7GB1:48

ENT RESET

ESC MUTE

The amount of data remaining to be transferred (shown in gigabytes), and time will be displayed in decreasing increments as the percentage of completion increases.

Note: The copying speed, capacity and duration may vary from one source hard drive to another.

4.Once duplication is complete, a job status screen will be displayed.

1. HDD

ENT

 

 

OK:1

Fail: 0

 

 

ESC

RESET

MUTE

14www.aleratec.com