Using the RoboJet Disc Autoloader
Getting to know the Aleratec Autoloader application
A |
|
B |
|
C | G |
D | H |
E | I |
F | J |
A.Printer Status Panel – Shows the status of your RoboJet Disc Autoloader equipped printer, if one is detected.
B.Dry Disc Timeout – Sets a delay before dropping a completed disc into the bin for discs that need a little more time to dry.
C.Refresh Devices button – Rescans your hardware to identify your RoboJet Disc Autoloader equipped printer.
D.Flip Down button – Sends a command to the autoloader to release a disc that is in the disc tray to the disc bin.
E.Tray In button – Sends a command to the autoloader to load the disc tray into the printer.
F.Device Status – Shows the status of RoboJet Disc Autoloader.
G.Load Disc button – Sends a command to the autoloader to load a disc into the disc tray.
H.Flip Up button – Sends a command to the autoloader to reset the disc release hinge on the disc tray to its normal position.
I.Tray Out button – Sends a command to the autoloader to unload the disc tray from the printer.
J.Start Autoloader button – Prepares the autoloader for printing discs. The autoloader must be started before any disc print jobs are kicked off.
Note: Closing the Autoloader application will minimize it to your System Tray.
16www.aleratec.com