Nameplate Location, Replacement Parts | Alliance Laundry Systems 75

Introduction

Nameplate Location

The nameplate is located at the rear of the machine. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance.

	1	1	1
	CFD19CCFD19C	CFD15C	CFD20C
18, 25 AND 35 MODELS		33, 40, 55 AND 75 MODELS	100, 135, 165 AND 200 MODELS
1	Nameplate

Figure 1

Replacement Parts

If literature or replacement parts are required, contact the source from which the machine was purchased or contact Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor.

Customer Service

For technical assistance, call (920) 748-3121.

8

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9001000

Image 10

Alliance Laundry Systems 75, 40, 33, 100, 135, 165, 200, 18, 55 manual Nameplate Location, Replacement Parts, Customer Service

Contents

Washer-Extractors Page Contents Explanation of Safety Messages Important Safety Instructions Safety Information Safety Decals Operator Safety Introduction Model Identification 100 135 165 200 Introduction Customer Service Replacement PartsNameplate Location Introduction Model Number Familiarization Guide 0001 Wash Cylinder Information General Specifications Model Overall DimensionsWeight and Shipping Information Door Opening Information Balance Detection Cylinder SpeedsCentrifugal Force Data Direct Steam Heating Optional Weight and Shipping Information RPM Specifications and Dimensions Main Switch Electrical Power Inputs Flushing Supply Dispenser Steam Connection Input Optional 88 mm 220 mm Mm 53.07 in mm 50 mm 34 mm Model 1168 mm 1575 mm 33.6 1010 mm 305 mm 360 mm 56.5 mm Installation Recommended Minimum Clearances Model 100 135 165 200 Installation Floor Load Data Model 100 135 165 200 Mechanical Installation Important Drawing is not to scale Pound 34 mm 22 mm 26.18 665 mm 26.77 50 mm 680 mm 30.71 780 mm 712 mm 34 mm 22 mm 30.12 765 mm 898 mm 42.52 47.24 1200 mm 40 mm 1200 mm 42.5 mm 1300 mm 33 mm 44.8 660 mm 55 mm 30.31 782 mm 45 mm Mounting Bolt Installation If Required Removing the Transport Brackets Front Rear 40 Models Drain Connection Rear of Machine Model 100 135 165 200 Minimum Drain ID Model Number of Machines Water Connection Water Supply Information Model 100 135 165 200 Electrical Installation Do not use a phase adder on any variable- speed machine Cycle Phase Wire Full Load Amps Installation Electrical Connection Remote Liquid Supply Connection Steam Requirements Steam Heat Option Only Steam Supply Information 18-75 100/135 165/200 Supply Programming Table Example Pumps 24V ~ Out-of-Balance Switch Automatic Lubricator Control Function Test Machine