Installing the Dryer . . .
STEP 1:
Position and Level
the Dryer Unit
For further assistance refer to Section on Location Requirements.
Install dryer before washer. This allows room for attaching exhaust duct.
Install the four rubber cups found in the accessory bag.
Place the dryer in position, and adjust the legs until the dryer is level.
DRYER
BASE
LEVELING
LEG
STEP 2:
Connect Dryer Unit Exhaust System
For further assistance refer to Sections on Location Requirements and Dryer Exhaust Requirements.
WARNING
A clothes dryer produces combustible lint. To reduce the risk of fire and combustion gas accumulation the dryer MUST be exhausted to the outdoors.
•DO NOT use plastic or thin foil flexible ducting.
•Locate dryer so exhaust duct is as short as possible.
•Be certain old ducts are cleaned before installing your new dryer.
•Use 4" (10.2 cm) diameter rigid or flexible metal duct.
•Use as few elbows as possible.
•Use duct tape on all joints.
•Failure to exhaust dryer properly will void warranty.
RUBBER | D355IE1A | |
CUP | ||
|
D354IE0C | D356IE0B |
DO DON'T
NOTE: Venting materials are not supplied with the dryer (obtain locally).
(continued)
10 | 504524 |