Allied Telesis AT-8700XL Command Reference Updates, Activate cpu extended, Disable cpu extended

Software Version 2.8.1 11

	Command Reference Updates
	This section describes each new command and the changed portions of
	modified commands and output screens. For modified commands and output,
	the new parameters, options, and fields are shown in bold.
	activate cpu extended
Syntax
	ACTivate CPU EXTended STARt=1..100 [STOp=1..100]
Description	This new command lets you set monitoring so that it captures data when the
	CPU experiences a specific amount of instantaneous usage.
	The start parameter sets the percentage of utilisation the CPU must equal or
	exceed before it can begin capturing data. When CPU utilisation reaches the
	parameter, the router or switch begins capturing data. It continues until
	utilisation falls below the stop parameter, or until it captures 500 entries (10
	seconds worth).
	The stop parameter sets the percentage of utilisation the CPU must reach to
	stop data capturing. If CPU utilisation falls below the stop percentage before
	the router or switch has 500 data entries, then the router or switch resumes data
	capturing the next time utilisation reaches the start percentage. When the
	router or switch has 500 entries, it stops collecting data.
Example	To capture extended CPU utilisation data when CPU utilisation exceeds 70%
	and until it falls below 50%, use the command:
	act cpu ext star=70 sto=50
	disable cpu extended
Syntax
	DISable CPU EXTended
Description	This new command stops data capture of CPU utilisation, and resets
	parameters in the activate cpu extended command.
Example	To stop capturing extended CPU utilisation data, use the command:
	dis cpu ext
	enable cpu extended
Syntax
	ENAble CPU EXTended
Description	This new command lets you capture up to 500 data entries (10 seconds) of CPU
	utilisation data. Extended monitoring is disabled by default. This command
	takes effect when you enter it, or use the activate cpu extended command to
	collect data during specific usage levels.
Example	To begin capturing extended CPU utilisation data, use the command:
	ena cpu ext

Software Version 2.8.1 C613-10477-00 REV B