Allied Telesis AT-8900, RAPIER I, AT-9900 Disable lldp cdp interface, Disable lldp cdp ppptemplate

194 CDP over WAN Interfaces Release Note

disable lldp cdp interface

Syntax DISable LLDP CDP INTerface=interface

where interface is the interface on which to disable CDP, one of:

■ethn

An Eth port, where n is the Eth port instance (for example, eth0)

■portm

A switch port, where m is the port number (for example, port2 for the switch port numbered 2)

■pppm

A PPP interface, where m is the interface number

Description This command disables CDP on a specified interface. For the specified interface only, the router or switch stops receiving CDP advertisements and deletes any existing neighbour entries.

CDP is enabled by default on all interfaces, even when it is disabled on the router or switch.

Example To disable CDP operation on PPP interface 1 of the router or switch, use the command:

dis lldp cdp int=ppp1

disable lldp cdp ppptemplate

Syntax DISable LLDP CDP PPPTemplate=template

Where template is a number from 0 to 31

Description This new command disables CDP listening on interfaces that are dynamically created using the specified PPP template.

Example To disable CDP listening for PPP template number 3, use the command:

dis lldp cdp pppt=3

enable lldp cdp debug

Syntax ENAble LLDP CDP DEBug={PACketADJacencyEVentPPP} Description This command enables CDP debugging in a particular debug mode.

CDP debugging can be enabled on one management device only at any given time, either an asynchronous port or a Telnet login. If a debugging mode is

Software Version 2.8.1 C613-10477-00 REV B