Allstar Products Group J6500 Installing the Operator, For These Types of Doors USE 1/3 HP

C:INSTALLING THE OPERATOR

IMPORTANT!

IDENTIFY YOUR DOOR TYPE FROM THOSE ILLUSTRATED BELOW AND FOLLOW

INSTRUCTIONS FOR THAT TYPE OF DOOR

104367

SECTIONAL DOOR	ONE PIECE DOOR
CURVED TRACK	HORIZONTAL TRACK
HIGH ARC OF	JAMB HARDWARE
	HIGH ARC OF
DOOR TRAVEL
	DOOR TRAVEL
TRACK
	TRACK
DOOR	DOOR

FOR THESE TYPES OF DOORS USE 1/3 HP

MODEL 6000 OR 1/2 HP MODEL 6500 OR 6500-P.

USE 7 FT, 8 FT OR 10 FT RAIL

(MATCH DOOR HEIGHT)

104368

ONE PIECE DOOR	ONE PIECE DOOR
NO TRACK	NO TRACK
JAMB HARDWARE	PIVOT HARDWARE
HIGH ARC OF	HIGH ARC OF
DOOR TRAVEL	DOOR TRAVEL

DOORDOOR

JAMB

HARD-PIVOT WARE

FOR THESE TYPES OF DOORS USE

1/2 HP MODEL J6500.

USE 7J RAIL

(FOR DOOR HEIGHT UP TO 8 FT)

WARNING

SPRINGS, PULLEYS, CABLES AND MOUNTING HARDWARE USED TO BALANCE YOUR GARAGE DOOR ARE UNDER EXTREME TENSION AT ALL TIMES AND CAN CAUSE SEVERE INJURY OR DEATH IF DISTURBED. DO NOT ATTEMPT ADJUSTMENT.

VERTICAL

HORIZONTAL CENTERLINE LINE

STEP 1: Mounting the Front Bracket — Sectional Doors and One- Piece Doors with Track (For One-Piece Doors without track see Step 1A, next): Mark a vertical centerline on the header above the door. By manually raising the door, determine the high arc of the door’s travel (see illustration, above left) and using a level, transfer this measurement to the header (see illustration at left). Draw a horizontal line, crossing the previously drawn centerline, at this point. Install the Front Mounting Bracket securely wit lag screws as shown on the following page. If necessary, reinforce the header with steel angle iron or wood to ensure a secure mount.

104369

WARNING

FRONT MOUNTING BRACKET MUST BE INSTALLED TO A STRUCTURAL SUPPORT (STUD) ON THE HEADER WALL. FAILURE TO DO SO COULD CAUSE SENSING SYSTEM TO MALFUNCTION, RESULTING IN ENTRAPMENT, INJURY OR DEATH. REINFORCE HEADER IF NECESSARY USING A 2 x 6 AND LAG SCREWS

(NOT PROVIDED).

7