American Audio Q-2411

and a compatible American Audio® or American DJ® CD Player. Using the mini plug included with

your CD player, connect from the CD player controller out jack to this jack. Player A “Q-Start”

functionallity will be controlled by the left side of the CROSSFADER (16). For more information on

“Q-Start” functionallity refer to the user manual included with your CD player. Be sure to only use

the mono tip mini plug included with your CD player to avoid damage to the mixer and/or the CD

player.

PLAYER 2 CONTROL - This jack is used to control the “Q-Start” function between the mixer

and a compatible American Audio® or American DJ® CD Player. Using the mini plug included with

your CD player, connect from the CD player controller out jack to this jack. Player B “Q-Start”

functionallity will be controlled by the right side of the CROSSFADER (16). For more information on

“Q-Start” functionallity refer to the user manual included with your CD player. Be sure to only use

the mono tip mini plug included with your CD player to avoid damage to the mixer and/or the CD

player.

31. BALANCED XLR MASTER OUTPUTS JACKS - The Master Output includes a pair of XLR

Balanced jacks as well as a pair of RCA UNBALANCED JACKS (29). The 3-pin XLR jacks send a

high current balanced output signal. These jacks should be used when you will be driving an amp or

other audio equipment with a balanced input, or whenever you will be running a signal line greater

than 15 feet. Always, use these jacks whenever possible.

32. AC CONNECTION - This connector is used to supply main power to the unit via the included

detachable power cord. The power connection use s an I.E.C. type connector, use only the supplied,

polarized AC power cord. Use on ly a power cord that matches this t ype of connection. Be sure to

only connect this unit t o a power outlet that matches the printed power label on the unit. N ever use

a power cord when the ground prong has been removed or broken off. The ground prong is used to

reduce the ris k of electrical shock in case of an electrical s hort. This cord is designed to ﬁt in one

direction only. Do not attempt to force a cord if it does not ﬁt, be sure the cord is being inserted

properly.

33. AC VOLTAGE SELECTOR - This switch is used to change the operating voltage. Operating

voltage can be toggled between 115v or 230v/50~60Hz. Be sure the selector is set to the proper

voltage for your area before attempting to operate the unit. Always be sure main power is shut off

before change the position of the Voltage Selector Switch.

Q-2411™ REAR PANEL - CONTROLS AND FUNCTIONS CONT.