6. REMOTE CONTROL OPERATION continued …

6.2RECORD PATH SELECTION

• Make sure ‘personality’ is set to MAIN, press REC, then select Source within timeout period.

6.2.1 COPYING THE MAIN PATH TO ZONE2, ZONE3, OR RECORD

Select a MAIN Source first and for...

PIP

 

 

P

 

 

P AT

S

 

H

S

 

 

 

REC

• ZONE2 or ZONE3: Make sure ‘personality’ is set to Z2 (or Z3), then press COPY. COPY

•RECORD:Make sure ‘personality’ is set to MAIN, press REC, then press COPY.

Note: The only way to send digital inputs and 6-Ch S/E input to ZONE2, ZONE3, or RECORD is through the Copy function (see sections 5.2.1 and 7.4.5).

6.3SOURCE SELECTION

After selecting the desired Path (MAIN, ZONE2, ZONE3, or RECORD), press one of ten Source keys in the SSP SOURCE group.

PIP SWAP MOVE

COPY 2-Ch 6-Ch

CD AUX TAPE

SSP SOURCE

DVD TV SAT

 

 

P

 

 

P AT

S

 

H

S

 

 

 

REC

FM

AM

VCR

6.3.1SOURCE SEEK (Remote Control Only)

The SOURCE SEEK keys provides an easy way to find the active Sources. The

SOURCE SEEK

  keys go to the previous and next Source with a signal on it, while thekey

 

advances one Source at a time.

 

6.4DIRECT FM•AM STATION ENTRY (Remote Control Only)

When using the FM•AM Tuner, the station frequency can be entered as a four-digit number. For example, to tune into 98.3 FM, press and hold SELECT until the display shows “<blank>0.0” in the lower left corner, then press 0, 9, 8, 3.

STATUS

SELECT

6.5SLEEP TIMER (Remote Control Only)

If you would like to go sleep while listening to a program or music, the Sleep Timer will automatically turn the AVM 30 power off after a preselected time. So when you find yourself falling asleep at the ‘tube’, take the Remote Control and:

•Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will operate for that Path only).

ME

RS

TI

SLEEP

•The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle as follows: Second=60, third=90, fourth=Disabled.

•Once set, the time remaining appears as the number following ‘Zzz’ in the display.

6.6 ENABLE / DISABLE TIMERS (Remote Control Only)

To enable or disable all timers without entering the Setup, press and hold the SLEEP key until the display shows ‘ALL TIMERS’, then use the  keys to enable/disable (see section 7.4.1).

36