7.SETUP MENU continued …

7.4.11 SAVE / RESTORE SETTINGS

The AVM 30 enables you to save your entire Setup configuration. Two separate save files are provided: USER SETTINGS and INSTALLER SETTINGS. If your system is set up by your dealer, the configuration can be saved in the INSTALLER file by the dealer. You can then make further Setup adjustments – save those settings separately in your own USER file. FM • AM presets are also saved separately in USER SETTINGS and

INSTALLER SETTINGS.

If someone makes unwanted changes to the Setup Menu of your AVM 30, you can quickly and easily restore either the dealer’s INSTALLER settings or your USER settings, thereby preventing the need to run through the Setup procedure all over again. FM•AM presets saved in USER SETTINGS or INSTALLER SETTINGS will also be restored.

The original FACTORY DEFAULTS can also be reloaded at any time to reset the AVM 30 to the factory settings. As well, surround mode level, balance and bass/treble adjustments described in sections 5.6 and 5.7 will be reset to 0 dB, and Mode settings described in section 5.8 will be reset to ‘None’ for all Sources.

11. SAVE / RESTORE SETTINGS

a.SAVE USER SETTINGS

b.RESTORE USER SETTINGS

c.SAVE INSTALLER SETTINGS

d.RESTORE INSTALLER SET’NS

e.RELOAD FACTORY DEFAULTS

Save Settings:

You can save settings with or without the use of a Password. Passwords are very easy to set up (see section 7.4.12) and will protect both USER and INSTALLER files from being changed by anyone who doesn’t have the Password. New saves will overwrite the previously saved file. The AVM 30 will prompt you to confirm that you want to over-write currently saved settings – press BACK at this point to abort a save.

Restore or Reload Settings:

You may RESTORE USER SETTINGS, INSTALLER SETTINGS, or RELOAD FACTORY DEFAULTS at will. The AVM 30 will prompt you to confirm that you want to replace the current settings – press BACK at this point to abort a restore.

Example 1: Save User Settings.

Note: FM•AM Tuner presets will also be saved in USER SETTINGS.

•Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.

•Upon entering this menu item, ‘a. SAVE USER SETTINGS’ will be highlighted in red.

•Press SELECT. You will be asked to confirm that you want to over-write current settings.

•Use the  buttons and change to ‘Yes’. If you are using a Password (section 7.4.12), you will be asked for it. Use the 0 – 9 buttons to enter your Password. The On-Screen display message will then say ‘Saving Successful’, the Front Panel display will say ‘Done!’.

•When finished, press  to go to another menu item, or...

•Press BACK to leave the submenu and return to the main menu.

63