ELITE SERIES USER MANUAL | INSTALLATION |
you controller in that slot.
3.Insert the gold covered “fingers” into the slot and GENTLY rock the controller card into a firmly seated position.
4.Adjust your ribbon cables so they pass easily out through the back of the computer through the vertical openings in the rear of the case.
5.If you wish to install a second controller card, the same procedure outlined above would be used; except the “standard” slot number for second controllers is slot five. A third controller would normally go in slot four.
6.Replace the lid, remembering to slide the front edge into the case first, then press down on the two rear corners until they pop into place.
7.Your Elite product is now installed and the Apple II can be turned on. Your disk drive(s) can be placed in a convenient location, usually along side or on top of the computer.
See figures 1. and 1.2 for correct cable connections to the Elite and Disk If controller cards.
Page