Aquacal Heat Pump

THE FOLLOWING CODES WILL BE DISPLAYED AS PART

OF THE NORMAL OPERATION OR PROGRAMMING OF THE HEATER:

Operational & Programming Codes

FLO..... No Water Flow Detected. This code appears whenever the circulating pump is off, or when

the heater is not receiving correct water flow .

OFF..... System is Off. This code appears whenever heater has been turned off via the mode

selector button, or when the temperature set point has been lowered below 45

CFI...... Celsius/Fahrenheit Selection. This is a programming entry point to select in which format

the water temperature will be displayed.

ULC..... User Lock Code. This is a programming entry point; when activated, steps to the next

menu level: ELC.

ELC..... Enter Lock Code. This a programming entry point; permits end user to select a secret

code, thereby limiting access to the owner settings.

CFO..... Call Flex Options. This is a programming entry point; when used in conjunction with an

AquaCal Call/Flex option kit, permits the use of CALL or FLEX options.

FS....... Heater in Defrost Mode (Applicable to Heat-Only Units, only). This code appears as a

normal display during periods of lower air temperatures. Sequence follows:

Heat-Only Defrost Sequence: Fan continues to run and compressor is off. Compressor

will restart when air coil temperature rises to approximately 38°F.

LOC..... This is a Service Entry Point (not intended for use by the owner). The[LOC] code permits

service personal to enter a factory code for access to adjustable calibration and site-

dependant setup parameters. Service adjustments are available to authorized installation

and service personnel, only .

HEATER CONTROLS...continued

Failure to heed the following may result in equipment dam-

age and voiding of manufacturer’s warranty.

CAUTION !

Heat pumps contain no owner-serviceable components. Owner-initiated adjustments, beyond

the controller “LOC” code, must not be attempted. If adjustments are deemed necessary, the

owner should contact inst alling dealer or AquaCal Customer Support at (727-823-5642).