3.Make sure that the traction clutch and attachment drive clutch levers are fully disengaged.
4.Open fuel shutoff valve.
5.Set the engine shut off switch to the "On" position to start and operate the engine.
6.If engine is cold, apply choke. A warm engine requires less choking than a cold engine. See Engine Manual for detailed instructions.
7.Set throttle to proper starting position
8.Press starter button on engine until engine starts.
IMPORTANT: DO NOT operate starter more than 15 seconds per minute, as overheating and damage can occur. (If engine does not start, refer to Troubleshooting on page 28.)
9.Adjust choke as needed.
10.Disconnect power cord from outlet, then starter.
11.Set throttle to Part Throttle or Slow position for adaptation to outside temperature or travel. Set throttle to Fast position for normal operation.
Shut Off
1.Release both clutch levers and wait for all moving parts to come to a complete stop.
2.Run unit a few minutes after use to prevent
3.Move throttle to STOP position.
4.Set the engine shut off switch to the "Off" position to shut off a running engine.
USING THE BRUSH
After proper
1.Select speed control position and direction.
IMPORTANT: DO NOT overload unit capacity by sweeping at too fast a rate.
2.Engage the traction drive clutch first.
3.Engage the attachment clutch next.
Tips for Sweeping
To clear an area, run unit in an overlapping series of paths. For large areas, start in the middle and sweep debris to each side, so it is not cleared more than once.
ALWAYS direct discharge away from area to be cleared and with direction of the wind.
Snow is best removed as soon as possible after snow fall.
TRAVELING
To travel from one work area to another:
1.Set throttle to SLOW position or slightly higher.
2.Press down the handlebars enough to raise the front of the unit slightly off the surface.
3.Engage traction clutch without engaging the attachment drive clutch.
TRANSPORT
ALWAYS shut off engine and close fuel shutoff when transporting unit on a truck or trailer.
Use extra care when loading or unloading unit onto trailer or truck.
Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
STORAGE
| Keep all nuts, bolts and screws properly | |
WARNING: AVOID INJURY. Read | tightened and know unit is in safe working | |
condition. | ||
and understand the entire Safety | ||
section before proceeding. | Store unit in a cool, dry protected area. |
SHORT TERM | LONG TERM | |
Clean unit thoroughly with mild soap and low | ||
IMPORTANT: NEVER spray unit with high- | ||
pressure water or store unit outdoors. | Lubrication on page 18). Touch up all | |
Run unit a few minutes after each use to free | scratched painted surfaces. | |
unit of any debris. | Remove weight from wheels by putting | |
Close fuel | blocks under frame or axle. | |
Inspect unit for visible signs of wear, |
| |
breakage or damage. |
|
GB - 15