Blade
Left | Right |
|
Blade
Front
RearRear
Figure 23
Adjust Blade Height
Level and pitch the mower with the height adjusters on each deck lift bracket (Figure 24).
Loosen the jam nut on the deck lift bracket bolt about 1/4 turn to reduce clamp load on the height adjusters.
Loosen the jam nut on the deck adjuster bolt and then turn the bolt clockwise to raise the deck or counterclockwise to lower the deck. Tighten both jam nuts.
Height
Adjusters
DO NOT place blocks under reinforcement bar.
Figure 24
STORAGE
WARNING: AVOID INJURY. Read and understand entire Safety section before proceeding.
SHORT TERM
NEVER spray unit with
Inspect unit for visible signs of wear, breakage or damage.
Keep all nuts, bolts and screws properly tightened and know unit is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure water and lubricate (See Lubricate Unit on page 22 in Maintenance). Touch up all scratched painted surfaces.
Remove weight from wheels by putting blocks under frame or axle.
GB - 28