IIHardwareInstallaton .
II. HARDWARE INSTALLATION
Rear Panel Features
| CABLE SELECT |
|
|
|
DIGITAL ANALOG | SLAVE |
|
|
|
AUDIO AUDIO | MASTER | IDE INTERFACE |
| POWER |
DG RGG L | 39 |
| 1 | +5V G G +12V |
| 40 |
| 2 |
|
➅ ➄ ➃ ➂ | ➁ | ➀ |
D: Digital; G: Ground; R: Right audio channel; L: Left audio channel
NOTE: The pin settings or definitions of the connectors and jumpers are also engraved on the Rear Panel of your
1.Power Supply connector connects to the computer’s power supply.
2.IDE Interface connector connects to the
3.Device configuration jumper allows you to set your
4.Analog Audio line out connector has two channels, right (“R”) and left (“L”) audio outputs, and allows you to direct audio output from your
5.Digital Audio output connector offers high quality audio effect by outputting digital signal to a D/A converter or for recording to a digital audio tape (DAT) or professional audio recording system. The connector follows the
6.Testing jumpers are reserved for manufacturer’s internal testing/diagnostic purposes.
Setting Your
Set your drive as either the Master or Slave (default) drive by placing the jumper cap on the desired jumper ¬.
Slave Drive (Default) | Master Drive |
NOTE: If your computer only allows you to connect a maximum of two devices and you have two hard disks, remove the Slave hard disk — you need the other IDE connector for your
8 | ASUS |